Induction Hardening


Slide 1


fotografia 11.jpg


Induction hardening on Induterm

In the process of induction hardening, obtained the treatment of superficial layer of the piece.

You can get a hard surface and resistant, keeping the good core toughness. 

The deformations caused by heating are smaller compared with other means of conventional heating. 

The induction hardening process used in Induterm is a high-frequency process, where you can get layers of 2 to 5 mm tempered.

The induction hardening allows also to harden just localized areas of parts (wear areas), not being necessary to treat the parts completely.